Please read this manual completely before starting the installation.

Components

1. LED-driver
2. Ceiling mount with cable rope holder
3. Pendant with plus (+) and minus (-) cables

1. Attaching the ceiling mount

Attach the ceiling mount ­using the designated slots. Make sure to use the appropriate screws and dowels for the ceiling.

2. Mounting and connecting the pendants

For safety reasons and to ensure that the LEDs are not damaged, the pendants must be connected without voltage.

Please note that polarity reversal on the constant current side can lead to a defect in the LED.

2. a) Attach the pendants and adjust the height

Mount the pendants using the minus (-) cable marked with the black flag. Thread the cable into the knurled nut in the cable rope holder. When the cable comes out on top, use a thin tool (e.g. ­screwdriver) to push it sideways.

Push (do not pull) the cable through until the pendant has the desired length.

Screw the knurled nut in to lock the cable.

Cut the excess cable, but leave enough to connect it to the terminal ­connector.

2. b) Thread the plus (+) cable

Before threading the plus (+) cable, make sure the pendant stopped rotating.

Lead the plus (+) cable marked with a red flag through the opening in the cable rope holder.

Push (do not pull) the cable until it has little tension and firmly secure it with the grub screw.

Cut the excess cable, but leave enough to connect it to the terminal ­connector.

2. c) Finalize the connection

Strip the end of the minus (-) cable marked with a black flag and connect it to the terminal ­connector that is connected to the LED driver with the black cable.

Strip the end of the plus (+) cable marked with a red flag and connect it to the terminal ­connector that is connected to the LED driver with the red cable.

3. Connecting the individual pendants to the mains

The connections on the mains voltage side can be looped through and all connected in parallel to an LED dimmer.